Showing 1–9 of 43 results
-

$82.50
Bronze thumbscrew cast with Rolls Royce part number on thumb portion as original. Rolls Royce part number G73184. Two used per car. Material: Cast bronze Finish: Grey nickel Thread: 0 BA OAL: 1.275 Length under head: .765
-

$71.50
Boss for starter motor guard and gear box undershield screws on Rolls Royce Phantom II. Rolls Royce part number G53152. 3 Used per car. Material: Bronze Finish: Natural Thread: 2BA OAL: 1.304 Mounting hole ID: .125 Mounting hole centers: .875
-

$71.50
Boss for engine guard securing screws on Rolls Royce Phantom II. Rolls Royce part number E72705. Four used per car. Material: Bronze Finish: Natural Thread: 0 BA OAL: 1.375 Mounting holes ID: .136; .937 center
-

$33.00
Packard V12 ignition cable clamp to hold the ignition cable to the engine block. Packard part #2099018 or #221061 on page 144 of parts book for 1500, 1600 and 1700. Material: Steel Finish: Natural ID: .562 Width: .976 Length: 2.292
-

$22.00
Yoke for pull rod linkages for engine controls on Rolls Royce Phantom II. Rolls Royce part number E6788. Material: 12L14 Steel Finish: Manganese phosphate Thread: 2BA-32 Length: 1.027 Jaw width: .200 Clevis pin hole ID: .192
-

$18.50
Lock washer for steering column control tube. Used to lock control tube in place at bottom end of steering box on Rolls Royce Phantom II. Rolls Royce part number F.71841. Material: Carbon steel Finish: Manganese phosphate ID: .815 OD: 1.00 Thickness: .057
-

$16.50
Generator drive gear to shaft lock washer for use on Rolls Royce Phantom II. Rolls Royce part number 26553, “Washer, lock, for intermediate spindle nut”. Material: Carbon steel Finish: Natural OAL: 1.285 OD: 1.080 ID: 13/16 Full tab length: .545 Thickness: .036
-

$16.50
Rear water pump drive gear lock washer for use on Rolls Royce Phantom II. Rolls Royce part number E 72091, “Washer, lock, for pinion shaft nut”. Material: Carbon steel Finish: Natural OAL: 1.373 Inner tab: .250 OD: 1.095 ID: 13/16 Thickness: .036
-

$13.50
#2 BA 1 1/2 square head bolt for use on Rolls Royce Phantom II. Material: 12L14 Steel Finish: Manganese phosphate Thread: 2BA Thread length: .400 OAL: 1.675 Square: .310 Length under head: 1.500